S T E A LT H B O X
SB-VW-NB/10W3
Fits 1998-00 Volkswagen Beetle
Installation of this Stealthbox requires professional installation skills and tools. Please read this installation guide
thoroughly before beginning the project. It will guide you step by step through the installation. It is absolutely
vital that the enclosure be properly mounted to the vehicle according to these instructions. Failure to mount
the enclosure properly presents two problems: 1) The sub-bass performance will suffer due to the movement
of the enclosure and 2) A loose enclosure presents a serious safety hazard in the event of a collision or sudden
deceleration.
STEP 1: Remove the carpet from the floor of the trunk
including the rear flap and hardware used to secure it
(This hardware will be used later in the installation).
STEP 2: Remove the contents of the spare tire well.
STEP 3: Place the supplied wax square in the location
shown in Picture #1.
Picture #1
STEP 4: Fully insert the supplied bolt into the insert on the
bottom of the Stealthbox.
STEP 5: Place the Stealthbox in the trunk in its proper
location as shown in Picture #2 and push down firmly
to force the bolt head to make an imprint in the wax
square.
STEP 6: Remove the Stealthbox and locate the impression
in the wax square.
Picture #2
CAUTION: Check under the vehicle for any loose brake
lines, fuel lines or other hazards before drilling.
Always wear eye protection when drilling.
STEP 7: Drill a 3/8” hole in the location of the imprint
in the wax square.
Picture #3
Stealthbox SB-VW-NB/10W3
Stealthbox 2000
Sheet SKU#011143 Revision 03/15/01
STEP 11: Install the supplied rear trim panel with the
factory connectors that were used to secure the rear
flap of the factory floor/carpet that was removed in
Step #1. All pieces are shown in Picture #7.
Picture #7
Picture #8
Picture #9 shows the completed installation.
Picture #9
Supplied Materials:
1 - 3/8” x 1 1/2” Bolt
1 - 3/8” Fender Washer
1 - 3/8” Lock Washer
1 - Sheet Wax Square
1 - Floor w/Foam Stand-Offs
1 - Rear Trim Panel
Specifications:
Enclosure Type: Acoustic Suspension (Sealed)
Driver Type: 10W3-D2
Cont. Power Handling: 250 Watts
Nominal Impedance: Dual 2Ω
(Wired to 4Ω Mono)
1 - 1/2” Fender Washer (On Box)
1 - 1/2” Wing Nut (On Box)
10369 N. Commerce Parkway
Miramar, FL 33025
Stealthbox SB-VW-NB/10W3
Stealthbox 2000
Sheet SKU#011143 Revision 03/15/01
|