29715_D-1000is_IB 6/20/06 10:12 AM Page 1
Ion Glow Multi-Attachment Styler
Use and Care Guide
D-1000is
29715_D-1000is_IB 6/20/06 10:12 AM Page 4
Safety Instructions
1. Should the ALCI safety device trip (i.e.,
ALCI Safety Device
reset button pops out) during use, press
the reset button. Should the hair dryer
fail to reset, call 800-736-4648. Never
operate this appliance if it has been
dropped in water.
This hair dryer is provided with an
appliance leakage circuit interrupter (ALCI)
safety device built into the plug. This device
is designed to make the unit inoperable
under some abnormal conditions, such as
accidental immersion in water. The ALCI
safety device is equipped with a test button
so that its operation can be checked. This
unit should be tested before each use to
confirm that the safety device is
2. The dryer is designed to work on
ordinary household current only, 125
volts A.C., 60 Hz. It is not intended for
commercial use.
GROUND FAULT CIRCUIT
INTERRUPTERS CAN
SAVE A LIFE!
operational.
3. This appliance is equipped with an
automatic thermal limiter, which will
cycle off when overheated and come
back on when cooled down. If the unit
cycles off, unplug the cord for several
minutes before restarting.
To test:
After plugging in your hair dryer:
If you must use your hair dryer in the
1. Press the reset button on the
ALCI device.
bathroom, install a GFCI* now!
Your local electrician can help you decide which type is best for you –
a portable unit that plugs into the electrical outlet or a permanent
unit installed by your electrician. The National Electrical Code now
requires GFCI’s in bathrooms, garages, and outdoor outlets of all
new homes.
4. This appliance has a polarized plug
(one blade is wider than the other). As
a safety feature, this plug will fit in a
polarized outlet only one way. If the plug
does not fit fully in the outlet, reverse the
plug. If it still does not fit, contact a
qualified electrician. Do not attempt to
defeat this safety feature.
2. Press the test button. The reset button
will pop out. This verifies that the safety
device is operating properly.
3. Press the reset button to reactivate your
ALCI safety device.
Why do you need a GFCI?
Electricity and water don’t mix. If your hair dryer falls in water while
it’s plugged in, the electric shock can kill you– even if the switch is
“off.” A regular fuse or circuit breaker won’t protect you under these
circumstances. A GFCI offers you greater protection.
4. Your hair dryer is now ready for use.
Note: This unit may automatically trip
when unplugged. If so, the unit must be
reset after it is plugged in. If the dryer
doesn’t reset after following the above
testing procedure, call 800-736-4648.
A GFCI can save your life!
Compared to that, the price is small!
Don’t wait… install one now!
*GFCI is a sensitive device that reacts immedi-
ately to a small electric current leak by stopping
the electricity flow.
4
5
29715_D-1000is_IB 6/20/06 10:12 AM Page 6
Product Features
Thank you for purchasing
1875 Watts
®
Ceramic Grill
the Remington 1875 watt Ion
Removable Filter
Glow Multi-Attachment Styler
Please carefully read the
.
instructions contained in this
booklet, and keep them in a
safe place for future reference.
ION
Glow
LED
Key Features:
Narrow Air
Concentrator
Ionic Conditioning
Before
After
Negative ions neutralize the positive
ions that cause static and frizz, giving
hair a more healthy-looking shine.
Cool Shot
Ion Switch
6 Style Settings
3 Heats and 2 Speeds
Ceramic Protection
Emits far-infrared, radiant heat to help
dry water molecules inside the hair
strand. This fast and efficient process
helps prevent heat damage to the outer
cuticle for less frizz and more shine.
Complete Ion Control
ON for smooth, shiny hair OFF for
maximum volume or fine hair
6-foot Salon
Length Cord
Lift & Dry Diffuser
Hang Loop
Ion Switch
6
7
29715_D-1000is_IB 6/20/06 10:12 AM Page 8
How to Use
Hair Care Tips
■ To create a style with lots of body, apply
Cool Shot:
The Cool Shot sets the style by blowing a
cool stream of air. Press and hold cool shot
button to set style. Release button to return
to warm air flow.
Basic Drying Techniques
Hair Care Tips
volumizing mousse to towel dried hair.
Distribute it evenly from roots to ends,
then blow dry as usual. Hair will be soft,
shiny, and full of volume.
1. Gently towel dry hair to remove excess
water. Avoid rubbing hair with towel –
this creates split ends and frizziness.
Detangle hair with a wide-toothed comb.
■ Keep the dryer about 8 inches away
from your head to avoid burning your
scalp or damaging hair.
■ Always keep the dryer pointed down
the hair shaft to smooth the cuticle and
create a silky, shiny style.
■ For a super smooth, salon-like blow dry,
finish by running a straightening iron
over dried hair.
For straight, smooth hair:
2. Be sure dryer is turned off. Plug dryer
into an electrical outlet.
With the dryer turned off, attach the
concentrator to the end of the nozzle. Brush
hair from underneath using a large, round
brush or paddle brush. Pull hair down until
the hair is fully extended and taut. Run the
dryer slowly down the length of the hair
several times until dry. Repeat with all sec-
tions of hair until it is completely dried. Lock
in the style with Cool Shot.
3. Set the ion switch to the on position.
Turn the dryer on and set it to a high
heat and speed. Remove some of the
additional moisture from your hair by
briskly blowing it all over, using your
fingers to “comb” through hair.
■ To help prevent heat damage and add
shine, spritz damp hair with a heat
protection spray before blow drying.
■ For a quick touch-up between
shampoos, mist hair to dampen
it, then style with dryer.
4. When hair is almost dry, lower the heat
and speed to the desired settings and
begin to style.
For curly hair:
Use dryer on a low heat and speed setting
and move it quickly about your head. As
you dry your hair, scrunch it with your
favorite styling product or twirl strands of
hair around your fingers to add definition.
When finished drying, lock in the style with
the Cool Shot.
5. Set ion switch to off position. Divide hair
into manageable sections. Begin at the
nape of your neck and brush hair, follow-
ing the movement of the brush with the
dryer. Continue working your way up to
your scalp, then to the sides and the
front, drying small sections at a time.
6. Once your desired style is achieved, push
the Cool Shot button to set the style with
a cool flow of air.
8
9
29715_D-1000is_IB 6/20/06 10:12 AM Page 10
Warranty
Cleaning and Maintenance
Storage
Maintenance Instructions
The dryer needs minimum maintenance to
ensure the best performance and long life.
Full Two-Year Warranty
Spectrum Brands, Inc.
When not in use, unplug the unit. Allow it to
cool, and store out of reach of children in a
safe, dry location. Never wrap the cord
around the appliance, as this will cause the
cord to wear prematurely and break.
Handle cord carefully, and avoid jerking,
twisting, or straining it, especially at plug
connections.
Spectrum Brands, Inc. warrants this product
against any defects that are due to faulty
material or workmanship for a two-year
period from the original date of consumer
purchase. This warranty does not include
damage to the product resulting from
accident or misuse.
Money-back Offer
If within 30 days after you have purchased
your Remington® branded product, you are
not satisfied and would like a refund,
return it with the sales slip indicating
purchase price and date of purchase to the
retailer from whom it was purchased.
Spectrum Brands, Inc. will reimburse all
retailers who accept the product within 30
days from the date of purchase. If you have
any questions concerning the money-back
guarantee, please call 800-736-4648 in the
U.S. or 800-268-0425 in Canada.
■ Do not attempt to repair the appliance
yourself.
■ Keep all intake openings clear of dust
accumulation. See “Cleaning Instructions”
below. No other maintenance or
lubrication is required.
If the product should become defective
within the warranty period, we will repair
it or elect to replace it free of charge.
Please call 800-736-4648 in the U.S.
or 800-268-0425 in Canada.
■ If the cord becomes twisted due to use,
periodically straighten it. Store appliance
and cord where they will not be damaged.
Do not wrap cord around dryer.
SPECTRUM BRANDS, INC. SHALL NOT
BE RESPONSIBLE FOR ANY INCIDENTAL,
SPECIAL OR CONSEQUENTIAL DAMAGES
RESULTING FROM THE USE OF THIS
PRODUCT. ALL IMPLIED WARRANTIES,
INCLUDING BUT NOT LIMITED TO
IMPLIED WARRANTIES OF FITNESS
AND MERCHANTABILITY, ARE LIMITED
IN DURATION TO TWO YEARS FROM
DATE OF ORIGINAL PURCHASE.
125 VAC 60 Hz
Questions or comments:
Cleaning Instructions
The air filter should be cleaned regularly,
since a dirty or clogged filter will impair the
efficiency of the dryer.
Call 800-736-4648 in the U.S. or
800-268-0425 in Canada.or visit
REMINGTON is a trademark of ROVCAL, Inc.
1. To clean air filter, make sure dryer is
turned off and unplugged.
©2006 ROVCAL, Inc.
This warranty gives you specific legal rights
and you may also have other rights which
vary from state to state. Some states do
not allow the exclusion or limitation of
incidental, special, or consequential
damages.
2/06 Job# CS29715
T22-21341
2. Gently pull the air inlet grille away from
the dryer.
Spectrum Brands, Inc.
800-736-4648
3. Use a soft bristle brush to gently remove
any particles that are lodged in filter.
MADE IN CHINA
4. If the unit is dirty, wipe it with a damp
This product is listed by
cloth.
Underwriters Laboratories, Inc.
and bears the mark.
5. To replace the air inlet after cleaning,
align locking tabs and press back into
place to secure.
10
11
29715_D-1000is_IB 6/20/06 10:12 AM Page 12
|