Rosewill Turntable RME ULP01R User Guide

USB Turntable with built-in speaker  
RME-ULP01R  
User Manual  
Thank you for purchasing a quality Rosewill Product.  
complete warranty information and future support for your product.  
 
USB Turntable with built-in speaker RME-ULP01R  
User Manual  
INITIAL STARTING-UP  
MAINS CONNECTION  
Ensure that the mains voltage of your home corresponds to the operating voltage of the  
unit.  
AMPLIFIER CONNECTION  
Connect audio plugs to Alert input on your mixer or amplifier:  
Red plug into R/H channel input.  
White plug into L/H channel input.  
Playing a record  
- Remove dust cover from your turntable.  
- Place the record of your choice on the turntable. If it is a 45 RPM, do not forget to place  
the adapter on the record spindle.  
- Choose the desired playing speed using the Speed select switch  
between 33.3, 45 and 78RPM.  
- Put down the power knob.  
- Release the tonearm lock.  
- Push in the arm with your hand lightly.  
- Place the cartridge vertically over the first track of the record the turntable will start  
turning automatically.  
- Put down the cartridge slowly to the record then the turntable will play.  
- When records comes to the end, platter will stop automatically if the Auto-stop switch  
points to ON position.  
When the switch locates to OFF it can help to read some long Recorded records.  
NOTE:  
- Lift up the tonearm and put it on the rest.  
- Replace the protective cap on the stylus and close the tonearm lock.  
- Turn off power at mains.  
MAINTENANCE  
REPLACING THE STYLUS  
-Refer to the figures 1-8  
2
 
USB Turntable with built-in speaker RME-ULP01R  
User Manual  
NOTE:  
- Please exercise extreme care whilst performing this operation so as to avoid the tone  
arm and audio line wires from any damage.  
INSTALLING A NEW CARTRIDGE  
-Refer to the figures 5 & 6  
NOTES  
We advise you to clean your records with an anti-static cloth to gain maximum enjoyment  
from them and to make them last.  
We would also point out that for the same reason your stylus should be  
replacedperiodically (approximately every 250 hours)  
Dust the stylus from time to time using a very soft brush dipped in alcohol (brushing from  
back to front of the cartridge)  
WHEN TRANSPORTING YOUR RECORD PLAYER DO NOT FORGET TO:  
Replace the protective cap on the stylus.  
Put the rest clip into the pick-up arm.  
3
 

Q Logic Network Card FC User Guide
Q See DVR QSD2014 User Guide
Quadra Fire Indoor Fireplace 810 02901 User Guide
Radian Technologies Headphones VT R800 7040 00 User Guide
Rolls Stereo Equalizer REQ313 User Guide
Russell Hobbs Microwave Oven RHM2013 G User Guide
Sabrent Network Card NT WGHU User Guide
Samsung Cell Phone 4G LTE SMARTPHONE User Guide
Samsung Clothes Dryer DV50F9A6EVW User Guide
SECO LARM USA Security Camera EV 1726 NKGQ User Guide