Superior Ventilation Hood H1989 User Manual

HEARTH PRODUCTS  
KITS AND ACCESSORIES  
750,195M  
Rev. NC, 03/2006  
CHARCOAL CANOPY HOOD KITS  
INSTALLATION INSTRUCTIONS FOR CANOPY HOOD KITS  
FOR USE WITH UVF-36, UVFRC-3628, UVFRC-3628-H  
UVFRC-4228 & UVFRC-4228-H UNIVERSAL VENTFREE FIREBOXES  
GENERAL INFORMATION  
KIT CONTENTS:  
1 ea. Charcoal Canopy Hood  
3 ea. Screws  
These canopy hood kits are design to be fitted to the face of the appliance  
directlyabovethereboxopening. Inadditiontoprovidinganaesthetically  
pleasing appearance to your appliance installation, the canopy reduces  
heat effects to decorative mantels and finish materials located directly  
above the fireplace and reduces the Mantel / Trim clearances (see Figure  
4 in the Installation and Operation Manual).  
1 ea. Instruction Sheet  
Charcoal Canopy Hood Kits  
CAT. NO.  
H1989  
MODEL NO.  
WHERE USED  
NOTE: A canopy hood is a standard part for model UVF-36. This  
UVF-36, UVFRC-3628,  
UVFRC-3628-H (UVF-36 standard part)  
model requires a canopy hood on all installations.  
FC36  
FC42  
The manufacturer recommends that the installation and Operation Manual  
provided with the appliance be read completely and understood thoroughly  
before proceeding with the installation of these kits. ALL WARNINGS AND  
PRECAUTIONS IN THAT DOCUMENT APPLY TO THESE INSTRUCTIONS.  
H1990  
UVFRC-4228 & UVFRC-4228-H  
Table 1  
TOOLS NEEDED:  
INSTALLATION INSTRUCTIONS  
5/16" Nut Driver or Socket  
The factory-supplied canopy must be installed on the firebox for safe  
operation for model UVF-36 (this part is optional for other models).  
Step 1. Remove screen and rod assemblies as shown in Figure 1.  
Step 2. Align the canopy with the holes in the side frames.  
Step 3. Install three screws as shown in Figure 2.  
INSTALL ONLY WHEN APPLIANCE IS OFF AND COLD!  
Step 4. Make sure canopy is level and secure.  
Step 5. Reinstall screen and rod assemblies (see Figure 1)  
Removing Screens & Rods:  
Remove screws (see dotted  
lines). Pull out rods from  
locatingholesonsideofrebox  
opening.  
Reinstalling Screens & Rods:  
Insert rods into corresponding  
locatingholesonsidesofrebox  
opening, then reinstall screws  
as shown.  
Canopy  
Figure 2  
Figure 1  
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.  
LHP reserves the right to make changes at any time, without notice, in design, materials, specifications, prices and the discontinuance of colors, styles and products. Consult your local  
distributor for fireplace code information.  
LHP  
Printed in U.S.A. © 2006 by LHP  
1110 West Taft Avenue  
Orange, CA 92865  
P/N 750,195M REV. NC 03/2006  
Page 1 of 1  
 

Shark Vacuum Cleaner EP750ST User Manual
Sharp CRT Television 32SF560 User Manual
Silicon Power Computer comm Switch 74669003 User Manual
Singer Sewing Machine 11W8 User Manual
Sony Photo Printer UP CR20L User Manual
Sony Stereo Receiver FN User Manual
Splendide Washer Dryer WD2100 User Manual
Swann Security Camera ADW 300 2 User Manual
Swann Security Camera DVR Guardian User Manual
Sylvania DVD Player ZV450SL8 User Manual